|
||||||
|
||||||
| Back to the future | Previous news | |||
Here are a few pictures about what's going on at the shop. |
||||
Use "Back to the future" and "Previous news" to move in the sequence |
||||
| Click on the photos to see larger versions. | ||||
| 07/12/15 | ||||
 |
||||
| Gluing the bilge keels and twin skegs. I used the lengthened polymerization time (it's COLD) to screw on the stainless steel bands on all. | Preparing the fiberglass stripes which will cover the epoxy fillets on both sides of all keels and skegs. | Detail of a finished fillet. | ||
 |
||||
| General view of the hull with all keels and skegs. | One more epoxy coat before putting the finishing of this "Arwen" on hold. | Because I have just received the kit for the "Skerry" which I am in a hurry to build and try out. | ||
 |
 |
 |
||
| Detail view of the protection covering the pre-cut scarfs on the planking. | Setting up to glue planking scarfs | Gluing the scarf: the two #1 planks are glued at the same time, one on top of the other (with plastic film in between, so that don't stick together). Gluing pressure is applied by screwing a length of "2 by 2" accross the scarf. | ||
| Back to the future | Back | Previous news | ||
| Copyright © Arwen Marine Emmanuel Conrath 2008 www.arwenmarine.com | ||||
